TN IT130 How to set a Managed InTouch 2014 R2 Application to Read Only
This article from InSource shows how to set a Managed Intouch Application to read only in System Platform 2014R2.
- Author: Mike Viteri
- Published: 04/17/2015
- Applies to: System Platform 2014R2
To set an Managed Intouch Application to read only. You will need to go into Windowmaker then Special->Configure->Remote Access. You can then choose "Read Only access"
Note: You will need a read only runtime license to enable this feature. This feature should only be enabled if you don't want users to have write back access.