TN TM108 Ports required for ACP ThinManager
This article from InSource lists the ports that are required to use ACP ThinManager, which should be open in your firewall.
- Author: Dillon Perera
- Published: 01/31/2017
- Applies to: ACP ThinManager 9.0
|67||X||If using PXE boot, the PXE Server will use this port for IP Address Assignment.|
|69||X||On ThinClient startup TFTP is used to send firmware from the ThinManager server to the thin client.|
|1494||X||Used by ICA protocol in Citrix, if not using RDP.|
|1758||X||Used by ThinManager if Multicast is enabled. Note: This port can be configured from within the ThinManager Server software.|
- Used by the ThinManager Server to send configuration to the thin client.
- Used when there are multiple ThinManager Servers to maintain synchronization between them.
|3389||X||Used by RDP protocol.|
|4900||X||On ThinClient startup TFTP is used to send firmware from the ThinManager server to the thin client.|
|5900||X||Used for doing Shadowing of thin clients. This port can be configured in the ThinManager Server software.|
|ICMP||Used by WinTMC and Enforce Primary|
Information gathered from the ThinManager Knowledge Base: http://www.thinmanager.com/kb/index.php/Main_Page